You will hear a confirmation beep and the center line will turn green. Here you are, you are now ready to activate the automatic GPS guidance by pressing ALT + X. In the example opposite, you can easily round 88.6 ° to 90 °, especially since the GPS will not accept decimals. In A + Heading mode, you will have to declare a heading (expressed in degrees, like an angle): you will have to enter the angle that appears in your minimap at the bottom left. Continue for at least 15 meters and press ALT + E one last time to fix point B. In A + B mode, you will have to roll a few meters from your point of origin named A to a point named B: press ALT + E and start rolling a few meters in the right direction, press ALT + E again and you will see appearing the letter A superimposed. A + Heading : This mode will ask you to enter a heading expressed in degrees by pressing the button just below "Determine A".A + B : This mode is the default one and it will ask you to drive a few meters with your vehicle to draw the line that the GPS will use as a reference.The guidance mode will necessarily be AB line type. To determine the orientation of your guidance, ideally along the length of the field, you have two options that you will find by pressing CTRL + S and going to the second tab on the left (the cogwheel and the coil). If for example you choose "1", each time you click on "+", it will add 1 meter. You can also change the increment expressed in meters by selecting the working width precision. In some cases, it will not correctly detect the width and you will have to enter it manually using the + and - buttons just above. Obviously, don't forget to hitch up your tools beforehand. To determine the width of your tool and therefore of your row, go to the graphical interface of the GPS by pressing CTRL + S then click on the "automatic working width" button to automatically detect the working width of your tool or cutter bar. You will see the confirmation of satellite reception as well as the row number you are about to work on. Once at the edge of the field, properly aligned and with your tools attached, turn on the GPS by pressing the key combination ALT + C. The 3 essential steps to make the GPS work The appearance of the starfire on the cabin when you purchase the GPS option. The only exception to the rule is that the vehicles are in the “vehicles” category, which will all be already pre-equipped. On some vehicles, you will even see the typical dome of the GPS antennas appear on the roof of the cab (Starfire module at John Deere as shown in the photo of the 000R below). To be able to benefit from the assistance of the GPS in your vehicles, you will first have to go through the dealership box by purchasing the option for € 15. Function which is now available on PC / MAC via the additional mod. The idea is to make nice rows the width of your tool and string them together on each round trip to cover the entire surface of the field efficiently without risking going back to where the work has already been done. For those new to GPS, this is a mod that will help you maintain precise direction when working in the field.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |